A Standard Remote ID broadcast stops working halfway through an otherwise normal flight. What should the remote pilot do?

• A.Land as soon as practicable and correct the problem before flying again
• B.Climb promptly to a higher altitude, where the broadcast signal is more likely to be received again
• C.Ignore the failure and finish the planned flight, because an in-flight failure never matters

Why

If Remote ID fails during flight, the aircraft should be landed as soon as practicable, and the failure corrected before the next flight. Climbing does not fix a failed broadcast, and the failure cannot simply be ignored.

Source: FAA-G-8082-22 Ch. 1 · ACS knowledge area: Applicable Regulations · From the Regulations & Registration practice bank (REG-084).

Practice this category as a full test

More Remote ID In-Flight Failure questions

• Under 14 CFR Part 107, a small unmanned aircraft is an unmanned aircraft weighing how much on takeoff, including everything on board or attached?
• A recreational flyer is generally required to register an unmanned aircraft with the FAA when its takeoff weight is
• You plan to fly a 0.4-pound unmanned aircraft commercially under Part 107. Which statement about registration is correct?
• How much does FAA registration cost for one small unmanned aircraft, and how long is the registration valid?
• Where must the FAA registration number be placed on a small unmanned aircraft?